Adafruit - Breakout Boards, Sensors, and Kits

Take a deep breath in...now slowly breathe out. Mmm isn't it wonderful? All that air around us, which we bring into our lungs, extracts oxygen from...

AF-4867

The LTR390 is one of the few low-cost UV sensors available, and it's a pretty nice one! With both ambient light and UVA sensing with a peak spectra...

AF-4831

Dig out that old Wii controller and use it as a sleek controller for your next robot if you like. The Adafruit Adafruit Wii Nunchuck Breakout Adapt...

AF-4836

Introducing the FeatherS2 - The full-featured ESP32-S2 based development board in a Feather format from Unexpected Maker. The FeatherS2 is a power ...

AF-4769

This is the BH1750 16-bit Ambient Light Sensor from Rohm. Because of how important it is to humans and most other living things, sensing the amount...

AF-4681

Sensirion Temperature/Humidity sensors are some of the finest & highest-accuracy devices you can get. And finally, we have some that have a tru...

AF-4636

The AHT20 is a nice but inexpensive temperature and humidity sensor from the same folks that brought us the DHT22. You can take sensor readings as ...

AF-4566

The Raspberry Pi 4 Model B is the newest Raspberry Pi computer made, and the Pi Foundation knows you can always make a good thing better! And what ...

AF-4564

We dig the sleek lines and satisfying heft of this aluminum case. Handsomely designed and thoughtfully constructed with a built-in heat sink, this ...

AF-4553

A strain gauge is a type of electronic sensor used to measure force or strain (big surprise there). They are made of an insulating flexible backing...

AF-4541

The PyPortal Titano is the big sister to our popular PyPortal now with twice as many pixels! The PyPortal is our easy-to-use IoT device that allows...

AF-4444

Oh so handy, this little lipo charger is so small and easy to use you can keep it on your desk or mount it easily into any project! Simply plug it ...

AF-4410

We put a PermaProto half-sized proto board in a blender with a Pi Cobbler and out emerged this very tasty confection - the 40-Pin PermaProto for Pi...

AF-4353

The MSA301 is a super small and low cost triple-axis accelerometer. It's inexpensive, but has just about every 'extra' you'd want in an acceleromet...

AF-4344

Circuit Playground Bluefruit is our third board in the Circuit Playground series, another step towards a perfect introduction to electronics and pr...

AF-4333

This simple spring antenna matches great with any of our 900MHz RFM and LoRa breakouts, bonnets and Feathers. They're made of copper-clad wire so y...

AF-4269

While this may appear to be an electronic shuriken, it's actually a Multifunctional USB Digital Tester! This handy (pun intended?) tool can measure...

AF-4232

This 4-wire cable is a little over 150mm / 6" long and fitted with JST-SH female 4-pin connectors on one end and premium Dupont male headers on the...

AF-4209

This breakout board may well be the last current sensing solution you every need to buy. Not only can it do the work of two multimeters, but it can...

AF-4226

What's the size of a credit card and can run CircuitPython, MakeCode Arcade or Arduino? That's right, its the Adafruit PyBadge! We wanted to see ho...

AF-4200

Female header is like the duct tape of electronics. It's great for connecting things together, soldering to perf-boards, sockets for wires or break...

AF-4160

This is a mouse. But, hark, it's no generic mouse. It's the Official Raspberry Pi Mouse!It's optical for good resolution and precision, three butto...

AF-4113

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you! This is a 25 Pack of...

AF-2787

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you! This is a 25 Pack of...

AF-2781

By popular request, you can now get our 7-segment LED backpacks without the LEDs! These backpacks feature an HT16K33 I2C LED driver, they're simple...

AF-877

For those who are fans of our silicone-covered wires, but are always looking to up their wiring game. We now have Silicone Cover Ribbon cables! The...

AF-3891

The simplest way to make an electromagnet is to get a solenoid, pass some current through it, and then get a piece of soft iron inside the solenoid...

AF-3872

If you bought a servo from us you probably got a bunch of plastic add-ons that you can snap onto the rotating part of the servo. These are called '...

AF-3837

Combining coding and paper circuits has never been cuter!Created by Jie Qi and illustrated by K-Fai Steele, Love to Code: Volume 1 – Microsoft Make...

AF-3834

Whether you're raiding tombs or traversing nuclear fallout wastelands, this is the most heavy-duty enclosure for your project! Weatherproof? Check....

AF-3931

You're at New York's hottest cyberpunk club is Near Field Commune(ication), and it's got everything, Collin's wondrous, mind-blowing, heart-stirrin...

AF-3781

We've had a foot pedal switch in the store for a while but some people have contacted us asking if there was a way to retrofit it to perform variab...

AF-3739

Add a dazzling color display to your Feather project with this Adafruit Mini Color TFT with Joystick FeatherWing.It has so much stuff going on, we ...

AF-3321

The Raspberry Pi 3 Model B is the most popular Raspberry Pi computer made, and the Pi Foundation knows you can always make a good thing better! And...

AF-3775

Feather is the new development board from Adafruit, and like its namesake it is thin, light, and lets you fly! We designed Feather to be a new stan...

AF-2829

Every time someone posts on the Adafruit forums and says they need to have a really long cable for their Pi Camera (CSI) or Pi Display (DSI), we sa...

AF-3671