Breakouts, Boards & Electronics

The SparkFun AS7262 Visible Spectral Sensor Breakout brings spectroscopy to the palm of your hand, making it easier than ever to measure and c...

SF-SEN-14347

The ADXL377 is a small, thin, low power, complete 3-axis accelerometer with signal conditioned analog voltage outputs that has a full-scale range ...

SF-SEN-12803

Have you ever wanted your project to just “hibernate” until someone picks it up or moves it? It’s a great strategy for dramatically extending the b...

SF-SEN-11447

Sometimes you need a very small directional input device (world’s smallest game controller, anyone?) This 5-way tactile switch (up, down, left, rig...

SF-BOB-11187

The SparkFun AutoDriver board is based on the STMicro L6470 dSPIN stepper motor driver. This powerful chip allows you to control a stepper motor wi...

SF-BOB-13752

This is the SparkFun Pi Wedge, a small board that connects to the 40-pin GPIO connector on the Raspberry Pi and breaks the pins out to breadboard-f...

SF-BOB-13717

The TRS (tip ring sleeve) jack breakout is a simple board that allows a ¼" stereo audio jack to be soldered on to gain easy access to all of its br...

SF-BOB-13005

With SD and MMC memory prices dropping, the time is right for mass storage and datalogging. This breakout board will allow you to breakout the SD/M...

SF-BOB-12941

This is a breakout board for the Texas Instruments TXB0104 module. The TXB0104 is a 4-bit bidirectional voltage-level translator with automatic dir...

SF-BOB-11771

The TLC5940 is a 16 channel PWM unit with 12 bit duty cycle control (0-4095), 6 bit current limit control (0-63), and a daisy chainable serial inte...

SF-BOB-10616

This simple breakout board makes it easy to use our LED tactile switches in a breadboard, or your next project. Note: Populate the board according...

SF-BOB-10467

This is a breakout board for the SP3485 RS-485 transceiver IC, which will convert a UART serial stream to RS-485. The SP3485 is a half-duplex trans...

SF-BOB-10124

This breakout board uses the LTC3588 Piezoelectric Energy Harvester from Linear Technologies. This board can be used not only for harvesting piezoe...

SF-BOB-09946

This handy module keeps accurate time for years using a tiny coin-cell, and is very simple to connect to your Arduino project. A driver library all...

FT-RTC

Many of the most interesting sensors and devices are only available in 3.3V or even lower voltage versions, which can be a problem if you want to c...

FT-LEVEL

Cellular + GPS tracking, all in one? Oh yes! Introducing Adafruit FONA 808 MiniGSM + GPS, an all-in-one cellular phone module with that lets you ad...

AF-2542

Connect your Arduino to the Internet with this fine new FCC-certified WiFi module from Atmel. This 802.11bgn-capable WiFi module is the best new th...

AF-2999

Simple but effective - this sewable breakout board has a CR2032 coin cell battery holder soldered on, an on/off switch and 0.1" pitch breakout pins...

AF-1871

This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power...

AF-1362

Beguiled by a fancy new chip that is only available in a SOIC or (T)SSOP pinout? This breakout PCB set will make your life much much easier and get...

AF-1211

Add lots of touch sensors to your next microcontroller project with this easy-to-use 8-channel capacitive touch sensor breakout board, starring the...

AF-1602

This breakout board will solve all your current-monitoring problems. Instead of struggling with a multimeter, you can just use the handy INA169 chi...

AF-1164

Beguiled by a fancy new chip that is only available in a QFP or QFN pinout? This breakout PCB set will make your life much much easier and get you ...

AF-1162

PowerBoost is the perfect power supply for your power-hungry portable project! This little DC/DC boost converter module can run from 1.8V batteries...

AF-2030