Jumpers and Wiring

SS-110990032

Breadboard jumper wire 70pcs pack. Including 4 different length:200mm,165mm,125mm and 80mm.Perfect design for breadboard,you can use it over and o...

SS-110990029

Some customer complain that can not use Arduino to control Grove modules directly. So we make this Grove to 4 Pin 2.54 female jumper wire. With t...

SS-110990028

This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end. Dimensions...

SF-PRT-08671

This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end. Dimensions...

SF-PRT-08670

This kit has large alligator clips and heavy cable. Features: - Jaw openings of about 10mm. - 10 leads supplied, 2 o...

TB-WC6020

This is a simple three wire cable. Each cable is 6" long and is great for jumping from board to board or just about anything else. There is a 3-pin...

SF-PRT-13164

Pre-cut and pre-stripped wires simplify and speed up breadboarding work. Having exactly the right wire lengths for the job also makes your project...

PL-754

Pre-cut and pre-stripped wires simplify and speed up breadboarding work. Having exactly the right wire lengths for the job also makes your project...

PL-347

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST RE connector on both ends....

SF-PRT-10372

This is a simple four wire cable. Great for jumping from board to board or just about anything else. There is a 4-pin JST RE connector on both ends...

SF-PRT-10369

This is a simple six wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends....

SF-PRT-10366

This is a simple four wire cable. Great for jumping from board to board or just about anything else. There is a 4-pin JST RE connector on both ends...

SF-PRT-10364

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST RE connector on both ends....

SF-PRT-10362

This is a simple two wire cable. It has bare wires on both ends with a Molex A and B connector in the middle. With thicker 18 AWG wire, it’s better...

SF-PRT-09923

This is a simple four wire cable. Great for jumping from board to board or just about anything else. There is a 4-pin JST connector on one end, bar...

SF-PRT-09916

A super handy set of jumper leads to leave in the back of the car! Each battery clamp has a LED light built in, powered by built-in batteri...

TB-WH6012