Sensors in New Products

This immersible pump can be used to water your plants, make a fountain or waterfall, even change your fish tank wter.It works quietly with the sou...

DF-FIT0200

The Minisense 100 from Measurement Specialties is a low-cost cantilever-type vibration sensor loaded by a mass to offer high sensitivity at low fre...

SF-SEN-09199

The Minisense 100 from Measurement Specialties is a low-cost cantilever-type vibration sensor loaded by a mass to offer high sensitivity at low fre...

SF-SEN-09198

This is the XBee XB24-Z7UIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create ...

DF-TEL0054

This basic piezo sensor from Measurement Specialties is often used for flex, touch, vibration and shock measurements. A small AC and large voltage ...

SF-SEN-09197

This XBee Pro 50mW U.FL Connection is Discontinued Now, We recommend Xbee / Zigbee as a suitable replacement. This is the XBee XBP24-BZ7UIT-00...

DF-TEL0055

This basic piezo sensor from Measurement Specialties is often used for flex, touch, vibration and shock measurements. A small AC and large voltage ...

SF-SEN-09196

This RN-XV WiFly Module is Discontinued Now, We recommend Xbee / Zigbee as a suitable replacement. The RN-XV module by Roving Networks is a c...

DF-TEL0056

This is an Arduino GPS/GPRS/GSM shield from DFRobot. This shield with a Quad-band GSM/GPRS engine works on frequencies EGSM 900MHz/DCS 1800...

DF-TEL0051

The Powerline Ethernet Adapter(STP-PLC200PT/STP-PLC200PP-A) is a device which can deliver a fast Internet signal to the farthest corners of your...

DF-TEL0057

INTRODUCTION This is an Arduino CH4 gas sensor. It uses MQ4 probe which is able to detect nature gas, CH4. It is less s...

DF-SEN0129

INTRODUCTION This is an Arduino Propane Gas Sensor. It uses MQ6 probe to detect iso-butane, propane and liquefied petro...

DF-SEN0131

This is an Arduino LPG gas sensor. It has MQ5 probe which is very sensitive with LPG, natural gas , town gas. It is less sensitive with alcohol,...

DF-SEN0130

INTRODUCTION This is an Arduino Carbon Monoxide Sensor. It uses MQ7 probe to detect Carbon Monoxide (CO) concentrations...

DF-SEN0132

This is a waterproofed version of the DS18B20 Temperature sensor. Handy for when you need to measure something far away, or in wet conditions. Whi...

DF-DFR0198

This is an Arduino hydrogen gas sensor. It has high sensitivity to Hydrogen (H2) and less sensitivity to alcohol, LPG,cooking fumes . Hydrogen g...

DF-SEN0133

Overview This Carbon Monoxide (CO) and flammable gas sensor detects the concentrations of CO and combustible gas in the air and ouputs its re...

PL-1483

This non-contact liquid level switch can be triggered when the liquid level fall below the sensor attached to the outside surface of a non-metal...

DF-FIT0212

Overview This flammable gas and smoke sensor detects the concentrations of combustible gas in the air and ouputs its reading as an analog vol...

PL-1480

Overview This breakout board is designed to work with any of the MQ-series gas sensors, simplifying the interface from 6 to 3 pins—ground, +5...

PL-1479

The Type 5 Pocket Geiger Radiation Sensor from Radiation Watch is a highly sensitive radiation sensor designed for the embedded systems market. Cap...

SF-SEN-14209

INTRODUCTION This is a piezoresistive force sensor. The harder you press, the lower the sensor's resistance. Pressing ...

DF-SEN0136