New Products

This is the latest DS18B20 1-Wire digital temperature sensor from Maxim IC. Reports degrees C with 9 to 12-bit precision, -55C to 125C (+/-0.5C). E...

SF-SEN-00245

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3836

Sometimes you’ve got way too many inputs, or outputs… or both. How are you going to get them all connected to your Arduino? The Mux Shield, that’s ...

SF-DEV-11723

Copper tape has countless applications in electronics from creating low-profile traces for electrical components to RF-shielding and antenna-making...

SF-PRT-13828

Bipolar stepper motor wires are terminated with bare leads. Bipolar stepper motor wiring diagram. Overview This small hybrid bipolar step...

PL-1204

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3835

Infrared proximity sensor made by Sharp. Part # GP2Y0A21YK has an analog output that varies from 3.1V at 10cm to 0.4V at 80cm. The sensor has a Jap...

SF-SEN-00242

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3834

This LilyPad LED Micro is Discontinued Now, We recommend other LilyPad as a suitable replacement. Here is a simple, very bright purple LED Li...

DF-DFR0167-PU

Discontinuation notice: This product has been discontinued. As an alternative, please consider the SparkFun Inventor’s Kit for Arduino Uno – V3.2,...

PL-2187

Connect your Arduino to the Internet with this fine new FCC-certified WiFi module from Atmel. This 802.11bgn-capable WiFi module is the best new th...

AF-3060

Copper tape has countless applications in electronics from creating low-profile traces for electrical components to RF-shielding and antenna-making...

SF-PRT-13827

This is a clever little breakout board for both the RGB and R/G illuminated rotary encoders. On one side, it breaks out all of the RGB pins to stan...

SF-BOB-11722

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3832

Note: This product has been replaced by the newer SparkFun Inventor’s Kit – V3.1 (with Arduino-Compatible RedBoard). The newer version includes a...

PL-2186

Side-looking Infrared Emitters and IR Detectors. These simple devices operate at 940nm and work well for generic IR systems including remote contro...

SF-SEN-00241

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3830

This servo extension cable has three 22-AWG wires joining a male Futaba J connector and a female JR connector. Since a female JR connector can be...

PL-2185

Here is a simple, very bright pink LED LilyPad. Light up the night! LilyPad is a wearable e-textile technology developed by Leah Buechle...

DF-DFR0167-PI

5mm Pololu universal aluminum mounting hub on a stepper motor with a 5mm-diameter output shaft. These universal mounting hubs are designed t...

PL-1203

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3829

There’s a lot of Raspberry Pi information going around lately. Whether it’s Pi A, A+, B, B+, or Pi 2 B, any forum will have thousands of people giv...

SF-KIT-13826

Are you trying to make a quick dime from electronics? Why limit yourself to dimes? This coin acceptor will take three different kinds of coin! Whet...

SF-COM-11719

Embedded antenna for small, mobile applications. Basic unpackaged antenna with LNA. 5inch cable terminated with standard male SMA connector. Match ...

SF-GPS-00177

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3826

Feather is the new development board from Adafruit, and like its namesake it is thin, light, and lets you fly! We designed Feather to be a new stan...

AF-3061

Discontinuation Notice: This board has been replaced by the newer A4988 stepper motor driver carrier with voltage regulators, which is a drop-in ...

PL-1202

This servo extension cable has three 22-AWG wires joining a male Futaba J connector and a female JR connector. Since a female JR connector can be...

PL-2184

DFRduino GPS Shield for Arduino has now been updated to ublox LEA-6H. The LEA-6H is a high performance stand-alone GPS and GALILEO receiver ...

DF-TEL0044

Everyone knows and loves Raspberry Pi, but what if you didn’t need additional peripherals to make it wireless. The Raspberry Pi 3 is here to provid...

SF-DEV-13825

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3825

Discontinuation Notice: This board has been replaced by the newer A4988 stepper motor driver carrier, which is a drop-in replacement with additio...

PL-1201

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3824

Overview This hybrid stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 1.2 A at 4 V, allowing for a holding torque of...

PL-1200

This 12" (300 mm) Y-cable has female JR connectors on all three ends, so it can be used to make connections between devices with 0.1" 3-pin male h...

PL-2183

The pcDuino AV Kit includes everything you need to get your pcDuino powered, networked and connected to an HDMI enabled TV or monitor. If you don’t...

SF-DEV-11714

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3822

The upgraded Arduino Input Shield includes a two axis mini joystick (with moment switch) as well as four colored push buttons(Red,Yellow,Blue,Gr...

DF-DFR0008

Connector cable for the Lassen iQ. Hirose HFL (female) connector to SMA (female) bulkhead connector. This cable is not compatible with the UFL conn...

SF-GPS-00174

Your 5V system can wield great power with this big, beefy relay board. How does 20A on the NC contacts and 10A on the NO contacts at 220VAC sound? ...

SF-KIT-13815

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3820

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3819

This 12" (300 mm) Y-cable is typically used to connect two servos to a single servo port on an RC receiver or servo controller. It has a single f...

PL-2182

This Cubietruck is Discontinued Now, We recommend other best selling dev boards as a suitable replacement. Cubieboard3 (also name...

DF-DFR0281

2.4GHz Duck Antenna 2.2dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. 4" long.The FCC is...

SF-WRL-00145

In this world nothing can be said to be certain, except we need headers, headers, and more headers! Each pack contains five 36-pin short female ...

AF-3008

These premium 26 AWG stranded jumper wires are equivalent to our wires with pre-crimped terminals with 1×1 crimp connector housings already attach...

PL-3816

2.4GHz ceramic chip antennas. Very small antennas that work nicely with the Nordic ICs. Don’t expect these little guys to perform as well as their ...

SF-WRL-00144