New Products

Close up of one segment of a SK6812-based LED strip with the red, green, and blue LEDs on at their dimmest setting. Close up of an SK68...

PL-2529

PIR motion sensor SE-10 top view. Overview The SE-10 passive infrared detector senses motion of infrared light sources at the same wavelengt...

PL-1635

If you want to make a kit you'll need some solder. This 0.1 lb / 50 gram spool is a good amount, not too much (like 1 lb spools) and not too little...

AF-2473

This combo is built arround the DFRduino Mega (Arduino Mega Compatible), it comes with the mega sensor shield, the I2C LCD shield, a light senso...

DF-KIT0025

Add some jazz & pizzazz to your project with a color touchscreen LCD. This TFT display is 2.4" diagonal with a bright (4 white-LED) backlight a...

AF-2478

The DFRobot Vibration Sensor buffers a piezoelectric transducer that responds to strain changes by generating a measurable output voltage change...

DF-DFR0052

Close up of one segment of a SK6812-based LED strip with the red, green, and blue LEDs on at their dimmest setting. Close up of an SK68...

PL-2528

Overview This methane gas sensor detects the concentration of methane gas in the air and ouputs its reading as an analog voltage. The concentr...

PL-1633

This is a USB AVR programmer supported by offical Arduino IDE. Once the Arduino has lost its bootloader for some reasons, use this programmer to r...

DF-DFR0116

SparkFun has discontinued the SCP1000 absolute pressure sensor carrier; they suggest the BMP085 as a replacement. Overview This SCP1000 MEMS absol...

PL-1632

Trinket may be small, but do not be fooled by its size! It's a tiny microcontroller board, built around the Atmel ATtiny85, a little chip with a lo...

AF-1500

Note: This product has been replaced by the Weather Shield for Arduino. Operation SparkFun’s USB weather board is powered by USB or a separat...

PL-1631

This is quality DB9 female Connector that with solder tail package. DB9 connector is widely used for serial communication RS232, RS485 and RS42...

DF-FIT0109

Close up of one segment of a SK6812-based LED strip with the red, green, and blue LEDs on at their dimmest setting. Close up of an SK6812, w...

PL-2527

Note: This product has been replaced by the newer Arduino Uno. Overview The Arduino Duemilanove is a microcontroller board based on Atmel’s AT...

PL-1630

This is quality DB9 Male Connector that with solder tail package. DB9 connector is widely used for serial communication RS232, RS485 and RS422 ...

DF-FIT0108

Wow that's a tiny GPS antenna! This passive antenna is only 9mm x 9mm x 6.5mm in size, with a 50mm long uFL cable. Great for when you want to keep ...

AF-2460

Classic 9V connector terminated with 2-pin polarized Molex connector. 15cm in length. To supply the power to Arduino, we recommend the DC Power Ja...

DF-FIT0111

These tweezers have fine tips suitable for small surface mount (SMT) parts. They are made of corrosion-resistant, anti-magnetic stainless steel th...

PL-1628

Close up of one segment of a SK6812-based LED strip with the red, green, and blue LEDs on at their dimmest setting. Close up of an SK68...

PL-2526

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positi...

DF-FIT0110

Wow that's a tiny GPS antenna! This passive antenna is only 15mm x 15mm x 6.8mm in size, with a 50mm long uFL cable. Great for when you want to kee...

AF-2461