Robotics

The bionic robot hand is made up of acrylic material. It consists of 5 micro metal servos, joints and one hand base. The special mechanical struct...

DF-ROB0143

Gearmotor with bracket and hub. These light-weight brackets are specifically designed for Pololu’s 37D mm metal gearmotors. Each bracket fe...

PL-1084

PL-1067

The HD-1160A is one of our most popular miniature servos. It is an inexpensive, general-purpose actuator for small mechanisms that require a bit ...

PL-1046

Overview DRV8838 Single Brushed DC Motor Driver Carrier, bottom view with dimensions. TI SN754410 (16-pin DIP) next to the #2135 DRV8835 c...

PL-2990

This is a bulk-packaged version of our DRV8825 Stepper Motor Driver carrier that ships without header pins; we carry compatible 0.1″-pitch 40-pin ...

PL-2977

The two-layer Circular Robotics Chassis Kit is a sturdy, miniature robotics kit designed for beginners and experienced roboticists alike. The chass...

SF-ROB-14332

Overview These tiny brushed DC gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and with five different motors: high-...

PL-992

These plastic mounting brackets allow you to easily and securely mount the ubiquitous 10 mm × 12 mm × 26 mm metal gearhead motors first popula...

PL-989

Note: We have released an improved ball caster with 1″ plastic ball that we recommend over this older version for applications that are not someho...

PL-956

How it works The Sliding Mouse moves via vibrations from a motor that spins a plate with an off-center weight. This spinning weight generates a r...

PL-941

Metal long standoffs: 1" long x ¼" OD. Used to get your proto board up off the table. #4-40 thread. Fits most development boards with available hol...

SF-PRT-10738

Overview This motor driver board is an add-on for a compatible Raspberry Pi (Model B+ or newer), including the Pi 3 Model B+ and Model A+, tha...

PL-2756

Pololu DRV8835 dual motor driver board for Raspberry Pi, top view with dimensions. Overview This motor driver kit and its corresponding P...

PL-2753

Add more power to your robot with this metal-geared MG90S servo. The tiny little servo can rotate approximately 90 degrees (45 in each direction), ...

AF-1143

Standard Philips-head 4-40 screws. They are ½" long and come in packs of ten. This is the screw size we use in most of the holes for our breakout b...

SF-PRT-10452

Brace yourself! You'll definitely want to pick up a couple of these corner brace supports when working on a project with 20x20 extrusion. They're n...

AF-1155

An essential for working with slotted aluminum extrusion, these slim metal nuts slide into the side-slot of the extrusion. The slightly oval shape ...

AF-1157

PL-2696

PL-2694

Overview These light-weight aluminum shaft adapters convert a typical motor output shaft into a 12 mm hex shaft that is compatible with many commo...

PL-2682

This pan/tilt bracket consists of two brackets and all the hardware you need to attach them to make a pan/tilt mechanism using two servo motors. We...

SF-ROB-10335