Sensors

Add motion and direction sensing to your wearable FLORA project with this high precision 3-axis Accelerometer+Compass sensor. Inside are two sensor...

AF-1247

Combining an accelerometer, a magnetometer, and a gyroscope all in one tiny package with an Arduino-friendly I2C interface. Perfect for building a...

FT-IMU9

 Sense magnetic presence, rotating wheels and magnets, door and arm sensors, and anything else magnetic nearby this sensor.Click here for our Hall ...

FT-HALL

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. If you...

SF-BOB-13878

Overview These sensor modules are based on Vishay’s TSSP77038 modulated infrared receivers. Unlike most IR receiver modules designed for remo...

PL-2578

Which way is up?This tiny 3-axis accelerometer module can operate in either +/-1.5g or +/-6g ranges, giving your project the ability to tell which ...

FT-AM3X

The Si7021 is a low-cost, easy-to-use, highly accurate, digital humidity and temperature sensor. This sensor is ideal for environmental sensing and...

SF-SEN-13763

This tiny breakout board features the ADMP401 MEMS microphone. One of the key advantages to this breakout and microphone is the bottom ported input...

SF-BOB-09868

This new version adds 2 standoff holes as well as an extra decoupling capacitor. The ADXL345 is a small, thin, low power, 3-axis MEMS accelerometer...

SF-SEN-09836

The Arduino XBee shield is designed to meet wireless sensor networks such as wifi, bluetooth 2.0/4.0 and zigbee. The module is easy to use, low po...

DF-DFR0015

The TSL235R light-to-frequency converter outputs a square wave (50% duty cycle) with frequency directly proportional to light intensity (irradiance...

SF-SEN-09768

The NXP Precision 9DoF breakout combines two of the best motion sensors we've tested here at Adafruit: The FXOS8700 3-Axis accelerometer and magnet...

AF-3463

This very long force sensitive resistor - over 2 feet - has a sensing area of 0.25x24". This FSR from Interlink Electronics will vary its resistanc...

SF-SEN-09674

Do you need a servo for a tiny little project? Or are you seeking for an affordable solution? This mini servo is quite impressive, it does quite t...

DF-SER0006

DF-BluetoothV3 Bluetooth module uses a unique double-board design, it is beautiful and aim to prevent electrostatic damage to the module. It is de...

DF-TEL0026

A simple breakout PCB for the GP1A57HR photo interrupter (also known as a photogate, photodiode, or phototransistor). This PCB has three connection...

SF-BOB-09322

Breakout board for the Analog Device ADXL345. The ADXL345 is a small, thin, low power, 3-axis accelerometer with high resolution (13-bit) measur...

DF-SEN0032

Standard 16x2 character LCD display. It has a basic 16 character by 2 line display with a blue background with white characters. You could get a c...

DF-FIT0127

This pressure sensor from Freescale is a great low-cost sensing solution for precision measurement of barometric pressure and altitude. The MPL3115...

AF-1893

When the future is dazzlingly-bright, this ultra-high-range luminosity sensor will help you measure it. The TSL2591 luminosity sensor is an advance...

AF-1980

The VCNL4010 sensor is a nice way to add a small-distance proximity sensor to your microcontroller project. For longer distances (in the range of c...

AF-466

Using our muscles to control things is the way that most of us are accustomed to doing it. We push buttons, pull levers, move joysticks… but what i...

PI-AT-04-001

A really sophisticated and accurate colour and luminance sensor breakout that's Raspberry Pi and Arduino compatible. As well as detecting RGB colou...

PR-PIM375

We stock a few barometric pressure sensors, great for altitude and weather measurements. This pressure sensor is special because it comes with a me...

AF-3965