SparkFun Australia

This is SparkFun Terror-Min, the wonderful toy to annoy and bring terror to the most patient parents. It’s a simple kit based on the principals of ...

SF-KIT-09206

This is a large mass of items that go along with the Beginning Embedded Electronics lectures. You will get all the following parts in a kit to go a...

SF-KIT-08373

This is the new UAV Development Board v3 (aka, UDB3). The UDB3 board comes with a dsPIC30F4011 CPU, an MMA7260 three axis accelerometer, and two du...

SF-GPS-09980

This is the RFduino Dual AAA Battery Shield, a long add-on board for the RFduino DIP module that supplies 3.3V to your whole project. This shield c...

SF-DEV-13214

This is the RFduino Proto Shield, a finger-tip sized board that can be attached to the main RFduino Dip module to create your own custom circuits a...

SF-DEV-13213

This is the RFduino Servo Shield, a small board that can be used with the RFduino DIP module to drive up to 4 servos at once. This pretty much as s...

SF-DEV-13211

The Intel® Galileo Gen 2 board is based on the Intel® Quark SoC X1000, a 32-bit Intel Pentium®-class system on a chip (SoC). It is the first board ...

SF-DEV-13096

The CryptoCape is the BeagleBone’s first dedicated security daughterboard and was made in collaboration with our Hacker In Residence, Josh Datko. K...

SF-DEV-12773

At SparkFun we use many Arduinos and we’re always looking for the simplest, most stable one. Each board is a bit different and no one board has eve...

SF-DEV-12757

This is a shield for the CC3000 WiFi Module. The CC3000 from TI (Texas Instruments) is a self-contained wireless network processor that makes incor...

SF-DEV-12071

The SparkFun Danger Shield mounts on top of your Arduino or Arduino Pro and equips it with a variety of fun and useful inputs and outputs. The Dang...

SF-DEV-11649

When you think about a piece of equipment like a mixed signal oscilloscope you usually think of, well, a piece of equipment. What you probably don’...

SF-DEV-11643

The Netduino Plus is an open source electronics platform using the .NET Micro Framework. The board features a 32-bit microcontroller and a rich dev...

SF-DEV-11608

You hear it all the time in the Arduino community, “will this shield work with my other shield?.” I think we’ve all been disappointed to find that ...

SF-DEV-11002

If you’re looking for a simple way to add a battery to your LilyPad project, the LilyPad Coin Cell Battery Holder might do the trick. It’s a simple...

SF-DEV-10730

Are you a Java developer looking to add advanced hardware I/O capabilities to your Android or PC application? Well, then the IOIO-OTG is for you! T...

SF-DD-13964

The EZO-PMP Kit from Atlas Scientific is a small peristaltic dosing pump and serial controller with all the parts needed to set up a nice home lab ...

SF-KIT-14454

The SparkFun BlackBerry Trackballer Breakout gives you easy access to a trackball which measures up, down, left, and right movements, clicks on the...

SF-COM-13169

The ATMega2561 is one of Atmel’s low-power 8-bit AVR RISC-based microcontrollers. This SMD microcontroller features 256KB self-programming flash pr...

SF-COM-12906

Do you need that extra push over the cliff? The Large sized GTE (Goes To Eleven) Knob can fit onto potentiometers with a 6mm wide shaft thanks to a...

SF-COM-11950

These T junction ELastoLite® connectors are perfect for connecting multiple electroluminescent panels to a single EL inverter. Simply iron wires or...

SF-COM-11921

These contact patches are perfect for connecting circuit tape to ELastoLite® EL panels. Simply iron wires or ELastoLite® circuit wire between these...

SF-COM-11919

These are blue-green 5" x 3" electroluminescent (EL) panels from ELastoLite®. These EL panels are highly flexible, waterproof, and with a little bi...

SF-COM-11903

This is an 8 gig microSD memory card. It’s perfect for massive datalogging without taking up a lot of space. These microSD cards have a simple to u...

SF-COM-11609

No longer do you need to worry about what supplies to purchase to prepare for your next electric paint project. The Touch Board Pro Kit from Bare C...

SF-KIT-14533

4-digit 7-segment displays are really neat little devices, it’s a shame that they can be so cumbersome to control. Well we’ve solved that problem b...

SF-COM-11440

Metal is out; ceramic is in! This is a four-pack of Slice blades made of 100 percent hand-sharpened zirconium oxide. Each blade features a straight...

SF-TOL-14510

Rotary encoders can be used similarly to potentiometers. The difference being that that an encoder has full rotation without limits (It just goes r...

SF-COM-10984

Metal is out; ceramic is in! This is a four-pack of Slice blades made of 100 percent hand-sharpened zirconium oxide. Each blade features a curved e...

SF-TOL-14509

Want to control a standard wall outlet device with your micro controller, but don’t want to mess with the high voltage wiring? This might just be t...

SF-COM-10747

The Slice Craft Knife is a high-end hobby knife perfect for precision cutting, scraping and handling. Its ceramic safety blade requires no oil coat...

SF-TOL-14508