SparkFun Australia

Using our muscles to control things is the way that most of us are accustomed to doing it. We push buttons, pull levers, move joysticks… but what i...

SF-SEN-13723

4-digit 7-segment displays are really neat little devices, it’s a shame that they can be so cumbersome to control. Well we’ve solved that problem b...

SF-COM-11441

The SparkFun Soil Moisture Sensor is a simple breakout for measuring the moisture in soil and similar materials. The soil moisture sensor is pretty...

SF-SEN-13637

An assortment of colored wires: you know it’s a beautiful thing. Six different colors of stranded wire in a cardboard dispenser box. Sit this on yo...

SF-PRT-11375

This is a 4 pack of wires that are pre-terminated with an alligator clip on one end and a hookup pigtail on the other. Alligator clips are a staple...

SF-CAB-13191

This 2x20 shrouded header has the same number and spacing of pins as a Raspberry Pi so you can easily connect via ribbon cable to the low-level per...

SF-PRT-13054

These flanged ball bearings fit nicely into a ½" diameter hole and has a ¼" bore. This makes it perfect for all Actobotics channels, hub mounts, or...

SF-ROB-13012

The SparkFun Micro OLED Breakout Board breaks out a small monochrome, blue-on-black OLED. It’s “micro”, but it still packs a punch – the OLED displ...

SF-LCD-13003

This book is a complete electronics course in 128 pages! Author Forrest Mims teaches you the basics, takes you on a tour of analog and digital comp...

SF-BOK-10764

This is a 10 pack of Biomedical Sensor Pads, disposable electrodes that can be used to measure EEG, ECG and EMG levels. these little pads are perfe...

SF-SEN-12969

This is the SparkFun MOSFET Power Control Kit, a breakout PTH soldering kit for for the RFP30N06LE N-Channel MOSFET. This kit is extremely simple t...

SF-COM-12959

This is a basic SMA (Sub-Miniature A) male to female connector cable. Each cable is 25cm (9.8") long and has a 50Ω impedance that can handle freque...

SF-WRL-12861

Solenoids are a great way to induce linear motion for pushing, pulling or controlling switches and levers. According to the datasheet this solenoid...

SF-ROB-10391

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positiv...

SF-PRT-10288

This is a row of 40 break away headers spaced 0.1" apart with long pins on both sides. This header is especially useful when you need to connect a ...

SF-PRT-12693

This new version uses an SMD 5x2 header. This is a simple to use USB AVR programmer. It is low cost, easy to use, works great with AVRDude, and is ...

SF-PGM-09825

This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality ...

SF-DEV-09716

The BPW34 is a tiny, general purpose PiN photodiode. This photodiode has a ton of uses, one of which is to use it is a mini solar cell to power you...

SF-PRT-09541

The LN298 is a high voltage, high current, dual full-bridge motor driver designed to accept standard TTL logic levels and drive inductive loads suc...

SF-COM-09479

This is a force sensitive resistor with a square, 1.75x1.5", sensing area. This FSR will vary its resistance depending on how much pressure is bein...

SF-SEN-09376

Arduino empowers makers’ creativity and passion for innovation with a robust new board that’s perfect for all users, from beginners to experts – al...

SF-DEV-22633

Why use a heatsink and a case, when you can use a heatsink case?! This blue, anodised aluminium case for the Raspberry Pi 4 will give you 10-15°C o...

SF-PRT-15896

This is a Micro-HDMI video cable tailored to the Raspberry Pi 4B, supporting 4K HD resolution. There is no delay, no flash, the transmission is sta...

DF-FIT0648

The HM01B0 from Himax Imaging is an ultra low power CMOS Image Sensor that enables the integration of an “Always On” camera for computer vision app...

SF-SEN-15570

Think of the RedBoard Artemis as just another Arduino... That has BLE. And one megabyte of flash. And runs at less than 1mA. Oh, and it can run Ten...

SF-DEV-15444

If you want to get some sound out of your project but have a tight space budget, this is a good way to do it. This 0.5W, 8Ohm speaker is only 40mm ...

SF-COM-15350

The SparkFun Current Sensor Breakout is a high accuracy board that utilizes the ACS723 for moderate AC and DC current sensing applications. The AC...

SF-SEN-13679

Have you ever needed a cheap way to activate something from across the room? Infrared remotes are still the cheapest way to wirelessly control a de...

SF-COM-14865

This is a class 10 32GB microSD memory card, perfect for housing operating systems for single board computers and a multitude of other information....

SF-COM-14832

USB C is fantastic. But until we have converted all our hubs, chargers, and ports over to USB C this is the cable you’re going to need. Supporting ...

SF-CAB-14743

If you intend on using the LoRa or Sigfox connectivity on the LoPy4 you are going to need to connect a special antenna before beforehand otherwise ...

SF-WRL-14676

Let’s face it, wire strippers can be problematic to use if you aren’t sure what your doing and it could result in you accidentally wasting material...

SF-TOL-14872

This miniature straight bar load cell (sometimes called a strain gauge) can translate up to 500g of pressure (force) into an electrical signal...

SF-SEN-14728

These are your run-of-the-mill ¼ Watt, +/- 5% tolerance PTH resistors. Commonly used in breadboards and other prototyping applications, these 1M oh...

SF-PRT-14494

At SparkFun we continually like to inovate, update, and improve even when it comes to our very own development boards. We have multiple versions of...

SF-DEV-15123

The SparkFun Qwiic HAT for Raspberry Pi is the quickest and easiest way to enter into SparkFun’s Qwiic ecosystem while still using that Raspbe...

SF-DEV-14459