dfrobot

Time to upgrade! This is a upper deck PCB for the 2WD MiniQ Robot Chassis. It is compatible with 9g micro servo and URM ultrasonic mounting brac...

DF-DFR0310

DFRobot UPS HAT is an uninterruptable power supply shield designed for the Raspberry Pi Zero series, and also compatible with Pi 2/3/A+. The UPS HA...

DF-DFR0528

This is a mounting bracket designed for our URM ultrasonic sensor series.It is fully compatible with URM37 and URM04. You can also have this i...

DF-FIT0006

This rubber ring is used to afix ultrasonic sensor. It fits URM37 V4.0 Ultrasonic Sensor For Arduino / Raspberry Pi and URM04 Ultrasonic Sensor ...

DF-FIT0187

This URM05 Ultrasonic Range Finder is Discontinued Now, We recommend URM04 Ultrasonic Sensor as a suitable replacement. The DFRobot URM...

DF-SEN0003

An ultrasonic sensor measures distance by calculating the time difference between sending a signal and receiving an echo from an object. It uses...

DF-SEN0153

With an internal temperature compensation and accurate distance detection, URM08-RS485 is a combination of temperature measurement device and dista...

DF-SEN0246

This URM12 from DFRobot is the latest ultrasonic distance sensor designed for distance ranging or obstacle avoidance applications. The sensor offer...

DF-SEN0310

DFRobot URM13 is an ultrasonic ranging sensor with open single-probe. It supports TRIG Pulse-triggered ranging (SR04 compatible), UART, and I2C com...

DF-SEN0352

DFRobot URM14 RS485 Precision Ultrasonic Sensor(200KHz) is a high-frequency precision ultrasonic sensor for industrial use. The sensor measurement ...

DF-SEN0358

URM37 V4.0 Arduino Ultrasonic Sensor comes with temperature compensation which provides better distance measurement accuracy. It is very unique ...

DF-SEN0001

The USB-ProxSonar-EZ1 has a detection zone of ~5 feet and will allow for 8+ simultaneous sensors. The USB-ProxSonar-EZ ultrasonic proximity se...

DF-SEN0146

The USB-RLY16 provides eight volt free contact relay outputs with a current rating of up to 16Amp each. The processor is powered and instructed ...

DF-DFR0235

This is the most common A to B Male/Male type peripheral USB 2.0 cable for arduino.  It is compatible with most Arduino boardssuch as Arduino Mega,...

DF-FIT0056

qualMeter is an easy and cost-efficient DIY device, which can help you to simply diagnose the quality of your USB charging cable and charger in a ...

DF-FIT0517

qualMeter miniLoad is specially designed for extending the qualMeter Basic's charger output testing range. When plugging miniLoad into qualMeter B...

DF-FIT0518

qualMeter is an easy and cost-efficient DIY device, which can help you to simply diagnose the quality of your USB charging cable and charger in a ...

DF-FIT0519

This product is a driver-free camera with 30W pixels and 640*480 resolution. The camera is well compatible with both Raspberry Pi and NVIDIA series...

DF-FIT0701

Still using a big, bulky, traditional power adapter to charge your lithium battery? DFRobot provides you with a compact and efficient 7.4V lithium ...

DF-DFR0564

This GPS receiver brings much more accurate and faster positioning performance with stronger signal compared with traditional GPS receivers. It is ...

DF-TEL0137

This is an Ublox chip-based GPS receiver module of low power and high sensitivity that can receive 56 channels satellite signal. Compared with trad...

DF-TEL0138

Small and exquisite, this USB power detector displays charging voltage and current at same time in one screen. Checking power consumption of ardui...

DF-DFR0303

This is a high-quality 5V USB wall adapter that is ideal for supplying power to your LattePanda, Raspberry Pi, Arduino and other 5V devices that r...

DF-FIT0501

This is a new version of the FTDI breakout board features an Atmega8U2 programmed as a USB-to-serial converter, the same chip found on the Ardui...

DF-DFR0164

The USB 2.0 to RS422/RS485 Cable provides a simple and easy to connect between the USB and RS422/RS485 ports interface. Ideally for PC, thin cli...

DF-FIT0272

This USB to RS485 converter module( USB 1.1，USB 2.0，USB 3.0 compatible) can expand one RS485 asynchronous communication interface from a computer’s...

DF-FIT0737

This USB to TTL converter combine the USB-232-1 (USB to Single RS232 Adapter) and TTL-232-1 (Port-powered RS232/TTL converter) allows you to con...

DF-TEL0010

The MB1414 USB-ProxSonar-EZ1 sensor features one-inch resolution and serial data over an easy to use USB interface, providing both proximity and ra...

DF-SEN0279

A low power version of the USB-RLY16 module, the USB-RLY16L is powered solely from the USB bus and provides eight volt free contact relay output...

DF-DFR0173

USB/TTL Raspberry Pi GPS tracker is a small GPS location module. It is using L80-39 GPS chip, which includes 66 search channels and 22 simultaneou...

DF-TEL0119

This is a USB AVR programmer supported by offical Arduino IDE. Once the Arduino has lost its bootloader for some reasons, use this programmer to r...

DF-DFR0116

This VESA mount is specially designed for LattePanda or other SBC cases. It can be used with VESA compatible display and monitor stand to hide the ...

DF-FIT0899

When developing the veyron series advanced motor driver products, we found there's no good designed components for the cooling high-power integr...

DF-DWG0007

Veyron Servo Driver (24-Channel) is a multiple servo controller, especially designed for humanoid robots, spider robots, robotic arms, and many ...

DF-DRI0029