dfrobot

qualMeter is an easy and cost-efficient DIY device, which can help you to simply diagnose the quality of your USB charging cable and charger in a ...

DF-FIT0517

qualMeter miniLoad is specially designed for extending the qualMeter Basic's charger output testing range. When plugging miniLoad into qualMeter B...

DF-FIT0518

qualMeter is an easy and cost-efficient DIY device, which can help you to simply diagnose the quality of your USB charging cable and charger in a ...

DF-FIT0519

This product is a driver-free camera with 30W pixels and 640*480 resolution. The camera is well compatible with both Raspberry Pi and NVIDIA series...

DF-FIT0701

Still using a big, bulky, traditional power adapter to charge your lithium battery? DFRobot provides you with a compact and efficient 7.4V lithium ...

DF-DFR0564

This GPS receiver brings much more accurate and faster positioning performance with stronger signal compared with traditional GPS receivers. It is ...

DF-TEL0137

This is an Ublox chip-based GPS receiver module of low power and high sensitivity that can receive 56 channels satellite signal. Compared with trad...

DF-TEL0138

Small and exquisite, this USB power detector displays charging voltage and current at same time in one screen. Checking power consumption of ardui...

DF-DFR0303

This is a high-quality 5V USB wall adapter that is ideal for supplying power to your LattePanda, Raspberry Pi, Arduino and other 5V devices that r...

DF-FIT0501

This is a new version of the FTDI breakout board features an Atmega8U2 programmed as a USB-to-serial converter, the same chip found on the Ardui...

DF-DFR0164

The USB 2.0 to RS422/RS485 Cable provides a simple and easy to connect between the USB and RS422/RS485 ports interface. Ideally for PC, thin cli...

DF-FIT0272

This USB to RS485 converter module( USB 1.1，USB 2.0，USB 3.0 compatible) can expand one RS485 asynchronous communication interface from a computer’s...

DF-FIT0737

This USB to TTL converter combine the USB-232-1 (USB to Single RS232 Adapter) and TTL-232-1 (Port-powered RS232/TTL converter) allows you to con...

DF-TEL0010

The MB1414 USB-ProxSonar-EZ1 sensor features one-inch resolution and serial data over an easy to use USB interface, providing both proximity and ra...

DF-SEN0279

A low power version of the USB-RLY16 module, the USB-RLY16L is powered solely from the USB bus and provides eight volt free contact relay output...

DF-DFR0173

USB/TTL Raspberry Pi GPS tracker is a small GPS location module. It is using L80-39 GPS chip, which includes 66 search channels and 22 simultaneou...

DF-TEL0119

This is a USB AVR programmer supported by offical Arduino IDE. Once the Arduino has lost its bootloader for some reasons, use this programmer to r...

DF-DFR0116

This VESA mount is specially designed for LattePanda or other SBC cases. It can be used with VESA compatible display and monitor stand to hide the ...

DF-FIT0899

When developing the veyron series advanced motor driver products, we found there's no good designed components for the cooling high-power integr...

DF-DWG0007

Veyron Servo Driver (24-Channel) is a multiple servo controller, especially designed for humanoid robots, spider robots, robotic arms, and many ...

DF-DRI0029

VFD tube, vacuum fluorescent display, which was invented in Japan in 1967, typifies the display component of the vacuum electronic era. ...

DF-DFR0223

Get this vibration sensor to build a burglar alarm system to protect your property!This cost-effective vibration sensor, characterized by high sens...

DF-SEN0433

Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT c...

DF-DFR0745

This newly launched real-time voltage monitoring module is specially designed for battery-powered smart robot cars. It aims to protect the battery ...

DF-DFR0673

Vortex , a programmable robot designed for kids. Vortex is based on Arduino which allow it compatible with most Arduino programming language su...

DF-ROB0130

Vortex , a programmable toy robot designed for kids. It is an Android or iphone controlled toy. There are 5 games that kids can play with toge...

DF-ROB0129

This W5200 Ethernet Module is .NET Gadgeteer compatible, which uses the .NET Micro Framework to make writing code for your device as easy as wri...

DF-TOY0022

W5500 Ethernet with POE Mainboard is a new member in our Ethernet family. It is based on the ATmega32u4 and W5500 Ethernet chip, which is quite us...

DF-DFR0342

High quality switching 'wall wart' 'wall adapter' AC to DC 12V 1A wall power supply. These are switch mode power supplies which mean the output is...

DF-FIT0231

This is a 7.5V wall adapter. It is not commonly available in the market. The best part of this adapter is that it allows Arduino project to run in...

DF-FIT0253

This is a high quality 5V USB charger wall wart. Ideal for supplying power to your Arduino when there is no computer near by. It can be used as ...

DF-FIT0197

This is a 5V USB charger wall wart. Ideal for supplying power to your Arduino when there is no computer near by. It can be used as Arduino power...

DF-FIT0163