Sparkfun

The Qwiic Shield for Arduino connects the I2C bus (GND, 3.3V, SDA, and SCL) on any Arduino compatible board to the SparkFun Qwiic system. We’ve inc...

SF-SPX-14286

The Qwiic Shield for ESP32 allows you to quickly and easily connect multiple I2C devices to your SparkFun ESP32 Thing development board, using the ...

SF-SPX-14203

The Qwiic Shield for Photo connects the I2C bus (GND, 3.3V, SDA, and SCL) from the Particle Photon to the SparkFun Qwiic system. Just plug a Photo...

SF-SPX-14202

The Qwiic Shield for Raspberry Pi connects the I2C bus (GND, 3.3V, SDA, and SCL) on the 40-pin Pi connector to the SparkFun Qwiic system. Just plug...

SF-SPX-14292

The Qwiic Starter Kit was designed to allow users to get started with Arduino without the need for soldering or breadboarding. Hooking up a handful...

SF-SPX-14752

Ever found controlling stepper motors confusing? There are a huge variety of wires to get connected right: power, motor coils, and control lines. A...

SF-SPX-15951

Microswitches are an easy way to determine if your robot has hit a wall or if your gantry has reached an endstop, but why would you want to deal wi...

SF-SPX-15586

The MCP9600 is a high accuracy thermocouple amplifier equipped with an I2C interface, accessed over our Qwiic system. Inside the chip are two tempe...

SF-SPX-15508

The SparkFun Qwiic system is expanding greatly. But we understand there are other systems out there. The Qwiic to Grove cable allows interoperabili...

SF-SPX-14739

Everyone who sees this display lit up says it looks like something from a sci-fi movie. The OLED segments on this transparent display look almost l...

SF-SPX-14691

It’s beautiful here in Boulder, Colorado, but any newcomer to the area quickly discovers our wonderful 300 days of sunshine is tempered with the fa...

SF-SPX-14264

The Qwiic Visible Spectral Sensor uses the AS7262 visible spectrometer from AMS for spectral identification. What can you do with Reflectance Spect...

SF-SPX-14290

We took the Micro OLED and encapsulated it to make it water-resistant. Why? So your fish can watch TV. The Qwiic Water-Resistant OLED is a small m...

SF-SPX-14287

This 2x13 flat ribbon-cable fits the GPIO headers on the Raspberry Pi so you can easily connect to the low-level peripherals and get hacking! This ...

SF-CAB-11489

This 2x13 shrouded header has the same number and spacing of pins as the Raspberry Pi so you can easily connect via ribbon cable to the low-level p...

SF-PRT-11490

If this kit looks familiar, it should! The Raspberry Pi 2 Accessory Kit has been built specifically for the many of you who already own a RPi board...

SF-KIT-13791

There’s a lot of Raspberry Pi information going around lately. Whether it’s Pi A, A+, B, B+, or Pi 2 B, any forum will have thousands of people giv...

SF-KIT-13673

Everyone knows and loves Raspberry Pi, but what if you didn’t need additional peripherals to make it wireless. The Raspberry Pi 3 is here to provid...

SF-DEV-13825

The Raspberry Pi is THE new favorite of development platforms, so the last thing that you’d want is for something bad to happen to it. Why not prot...

SF-PRT-14025

How does a more compact and more economic Raspberry Pi sound to you? The Raspberry Pi 3 A+ is here and, like the Raspberry Pi 3 Model B+, it boasts...

SF-DEV-15139