SunFounder Q250 250mm FPV 4-Axis Racing Quadcopter Drone Frame Kit CC3D Hobbywing EMAX
Features
The SunFounder Q250 quadcopter is tailored for hobbyists and beginners for FPV flying.
It is a X-Shape quadcopter, more flexible and efficient than the H-Shape.
It runs the firmware of CC3D flight controller, working with the 2204 motor and the ESC.
Weight: 476 g; Duration of flight: 11 minutes; Working voltage: 11.1V
CC3D software debugging guide and the assembling videos of the aircraft are provided for you. For more information, refer to our wiki.
Technical Detail
Note: The remote control and its receiver are not included.
Introduction
The realization of FPV flying starts from having a SunFounder Q250 aircraft. The SunFounder Q250 is a multicopter tailored for the hobbyists for FPV flying. It features stability, flexibility and activity. You can realize a stable flight in a high or low altitude or in a forest with the SunFounder Q250. The skid landing damping sponge tubes bound onto the motors help stablize the flight and protect the frame through increasing the buffer between the frame and the land when the aircraft is landing.
It runs the OpenPilot firmware of the flight controller firmware and the electronic speed controller. This kit is designed to meet the hobbyists’ higher requirement of flying the aircraft. You can realize a stable flight in a small space or a rapid 3D flight based on your own configuration and parameter setting.
Related Recommendation
The SunFoundere 250 quadcopter kit uses the 6040 propellers blades. If you want to experience a violent 3D flight, the 5045 propeller blades are needed. For them, you are recommended to refer to THIS.
For the camera kit, you are recommended to refer to THIS.
For the FPV TFT LCD, you are recommended to refer to THIS.
For the FPV Image Transceiver Kit, you are recommended to refer to THIS.
The Remote Controller is available HERE.
Package included
1 x Upper Board
1 x Bottom Board
1 x Board for Fixing the Camera
1 x PR301 Li-ion Polymer Balance Charger
1 x 5V 3A UBEC
1 x BB Bong 1-8S Battery Indicator
1 x 12V 1.5A Power Adapter
4 x XRotor 15A Brushless ESC
1 x 3S 11.1V 1300mAH T-Plug Li-Po Battery
1 x CC3D Flight Controller
1 x Male T-Plug Adapter Cable(100mm)
1 x USB cable (black)
1 x Heat Shrink Tubing (black 100CM)
5 x Double-Sided Foam Tape(25mm*40mm)
20x Nnylon Zip Ties( white 150mm*2mm)
4 x Skid Landing Damping Sponge Tube
12x Banana Plug Female Bullet Connector (2mm)
12x Banana Plug Male Bullet Connector (2mm)
16x Screw
1 x Allen Wrench (K2.0)
1 x Strap for Binding the Battery (black 2*20cm)
Velcro Tape(10*2.5cm) x1(pair)
Quadcopter Arm (red x2 & white x2)
6040 CW/CCW Propeller (greenx2 & yellowx2)
CW/CCM Motor(black bullet x2 & white bullet x2)
