Waveshare RP2040-PiZero Development Board, Based On The Raspberry Pi RP2040 Dual-core Processor, 264KB SRAM And 16MB Onboard Flash Memory
Based On Raspberry Pi RP2040
Onboard DVI interface, TF card slot and PIO-USB port
RP2040-PiZero is a high-performance and cost-effective microcontroller board designed by Waveshare, onboard DVI interface, TF card slot and PIO-USB port, compatible with Raspberry Pi 40PIN GPIO header, easy to develop and integrate into the products.
- RP2040 microcontroller chip designed by Raspberry Pi in the United Kingdom
- Dual-core ARM Cortex M0+ processor, flexible clock running up to 133 MHz
- 264KB of SRAM, and 16MB of onboard Flash memory
- Onboard DVI interface can drive most HDMI screens (DVI compatibility required)
- Supports using as a USB host or slave via onboard PIO-USB port
- Onboard TF card slot for reading and writing TF card
- Onboard Lithium battery recharge/discharge header, suitable for mobile scenarios
- USB 1.1 with device and host support
- Drag-and-drop programming using mass storage over USB
- Low-power sleep and dormant modes
- 2 × SPI, 2 × I2C, 2 × UART, 4 × 12-bit ADC, 16 × controllable PWM channels
- Accurate clock and timer on-chip
- Temperature sensor
- Accelerated floating-point libraries on-chip
- 8 × Programmable I/O (PIO) state machines for custom peripheral support
Onboard DVI interface, PIO-USB port and TF card slot for more possibilities
for reference only, the 1.3inch LCD HAT and 7inch HDMI LCD (H) are Not included
Comprehensive SDK, Dev Resources, Tutorials To Help You Easily Get Started
* the DVI and PIO-USB functions are only supported in C environment and cannot be used at the same time
Dual-core ARM Cortex M0+ processor, flexible clock running up to 133 MHz
-
USB Type-C connector
for communication and program burning -
PIO-USB port
for using as USB host or slave via PIO -
DVI interace (Mini HDMI connector)
for driving DVI screen with HDMI cable -
TF card slot
SPI interface communication -
RP2040
dual-core processor, up to 133MHz operating frequency
-
W25Q128JV
16MB NOR-Flash -
RUN button
reset button -
BOOT button
Press it when resetting to enter download mode -
Lithium Battery Header
PH2.0 header, for connecting 3.7V Lithium battery, allows recharging/discharging the battery -
40PIN GPIO Header
Compatible with some Raspberry Pi HATs
RP2040-PiZero x1
