Cables

Replacement:CAB-11301. We now have branded USB cables! They’re “SparkFun Red” and have the flame logo embossed on the connector, sweet. This page i...

SF-CAB-00598

USB On-The-Go is a really useful USB specification! It allows some small devices that would usually be unable to act as a host to have limited host...

SF-CAB-11604

Your cell phone charges off of USB, but can you really trust that charging station at the airport? Now you can control when to allow data in or out...

AF-3439

High quality, power friendly and discrete USB A to Micro-B cables Available in a range of lengths for all possible uses (also available in red) Fea...

PI-CAB0228

High quality, power friendly and discrete USB A to Micro-B cables Available in a range of lengths for all possible uses (also available in red) Fea...

PI-CAB0225

A standard USB cable, commonly used to connect your PC to a peripheral such as a printer USB 2.0 compatible Colour : Black Length : 1m Connections...

PI-CAB0224

For those who are fans of our silicone-covered wires, but are always looking to up their wiring game. We now have Silicone Cover Ribbon cables! The...

AF-3889

This cute little coax is a champ in our RF kit! It has a right angle female U.FL (aka I-PEX) connector on both ends. Now instead of jerry-rigging a...

SF-WRL-15114

USB C is fantastic. But until we have converted all our hubs, chargers, and ports over to USB C this is the cable you’re going to need for basic US...

SF-CAB-15092

This 12" (300 mm) Y-cable is typically used to connect two servos to a single servo port on an RC receiver or servo controller. It has a single f...

PL-2182

USB A to Micro-B cable size comparison: standard cable (#1939) on left, thin cable (#1938) on right. This USB cable is five feet long (1.5 m) ...

PL-1938

The SparkFun Qwiic system is expanding greatly. But we understand there are other systems out there. The Qwiic to Grove cable allows interoperabili...

SF-SPX-14739

Cables for your Raspberry Pi camera module!

PI-CAB0307

This is a 200mm long 4-conductor cable with 1mm JST termination. It’s designed to connect Qwiic enabled components together but can be used for oth...

SF-PRT-14428

This camera cable is specifically designed to work with the Raspberry Pi Zero - Version 1.3! Just plug it into your Pi Zero's camera port and then ...

AF-3157

Need to expose HDMI, Ethernet, or USB to the outside of your project/enclosure? These lovely little 50cm panel mount extension cables are just the ...

PI-CAB0903

This handy USB extension cable will make it easy for you to enclose a device that has a micro-B type port. We think this would be most handy when p...

AF-937

This handy USB extension cable will make it easy for you to enclose a device that has a mini-B USB type port. We think this would be most handy whe...

AF-936

This panel mount cable will allow you to enclose a device that has a USB A port, and also converts it to a modern USB C connector at the same time....

AF-4053

This panel mount cable will allow you to enclose a device that has a USB Micro B port, and also converts it to a modern USB C connector at the same...

AF-4056

Turn a micro HDMI port into a 'regular sized' HDMI port with this handy adapter. Works great with the Beagle Bone Black, many cameras with video ou...

AF-1358

This RF adapter bit is great for anyone doing RF work. If your receiver/transmitter/transceiver has an MCX connector but you really want to tie it ...

AF-1531

The MyoWare Muscle Sensor is now designed to be wearable, allowing you to attach biomedical sensor pads directly to the board itself. However, ther...

SF-DEV-14109

Simplify your Internet of Things with a passive PoE injector cable. These are quite handy for projects that have Ethernet connectivity and also nee...

AF-435

INTRODUCTION This cable will supply power to anything that has a MicroUSB port. The cable does not transfer data, but it...

DF-FIT0459

This cable will let you turn a JST PH 3-pin cable port into 3 individual wires with high-quality 0.1" female header sockets on the end. We're carry...

AF-3894

That new Raspberry Pi® Model A or B computer you just got has a row of 2x13 pin headers soldered on - those are the GPIO (general purpose input/out...

AF-862

This cable will let you turn a JST PH 3-pin cable port into 3 individual wires with grippy mini alligator clips. We're carrying these to match up w...

AF-4030

This cable will let you turn a JST PH 3-pin cable socket into 3 individual tinned wires. These are great to match up with our JST 3-PH cables, for ...

AF-4046

USB C is quickly becoming more and more prominent in the maker community because, let’s be honest, who likes trying three times to insert USB into ...

SF-CAB-14909

Just about all electronics use TTL serial for debugging, bootloading, programming, serial output, etc. But it's rare for a computer to have a seria...

AF-70

The FTDI cable is a USB to Serial (TTL level) converter which allows for a simple way to connect TTL interface devices to USB. The VCC pins of this...

SF-DEV-09717

If you love DIY cable-rigging, then these HDMI adapters are right up your alley! Making custom HDMI cables has never been easier. Just grab one of ...

AF-3553

If you love DIY cable-rigging, then these HDMI adapters are right up your alley! Making custom HDMI cables has never been easier. Just grab one of ...

AF-3559

This is a high quality Category 5 (CAT5) patch cables is the solution to your internetworking needs. DOCUMENTS Cat 5 Definition

DF-FIT0116

No, this isn’t a tank tread, this is a 0.5m long Cable Carrier with 10x15mm bits composing its main body and two screw fasteners at each end for ef...

SF-ROB-13207

Featutes: Compatible with Makeblock electronic modules Length: 35cm Sold in pack of 4.

MB-14204

FPC cables are super thin and flexible. They're often used in electronics when a a round cable would be too bulky, especially if you're dealing wit...

AF-1682

These are standard alligator to alligator (crocodile) clip test cables. The alligator clip allow you attach the test point without hold the ca...

DF-FIT0112

This is a foot-long white audio cable that has been terminated with two TRRS connectors at each end. TRRS connectors are the 3.5mm audio-style conn...

SF-CAB-14163

This cable can serve as a generic, 6-conductor ribbon cable with 6×1 0.1" female connectors on both ends, but it is designed for chaining ShiftBri...

PL-1237

INTRODUCTION This is one of the essentials for household electricity security: whether for electric insulations, protect...

DF-FIT0430

Seamlessly transmit high-quality stereo audio with this 3.5mm Male/Male Stereo Cable.  Ideal for "passing the AUX cord," or connecting audio dev...

AF-2698

This cable is great for connecting to a 16-pin character LCD such as our 20×4 character LCD with backlight, or it can simply serve as a custom cab...

PL-973