Freetronics Australia

Standard hobby servo that rotates approximately 180 degrees. Comes with a variety of horns, mounting screws, and rubber mounting bushes. Note: If...

FT-SSERVO

Retired: This product has been replaced by the Security Sensor Shield. This shield allows up to 4 security sensors to be connected to an Arduino w...

FT-SH-SECSENSE

This product has been retired. It has been replaced by the DLOCK Door Lock Shield: www.freetronics.com/dlock This shield allows your Arduino to co...

FT-SH-RFIDLOCK

This product has been superseded by the Receiver Shield 315MHz / 433MHz. Click here for the new model. This page is left for reference only, and th...

FT-SH-433MHZ-RX

This product has been replaced by the 16x2 LCD & Keypad Shield This simple shield gives you a 16-character by 2-line display and some handy in...

FT-SH-16X2LCD-KIT

Ever wanted to build your own small robot? Maybe you're interested in NodeBots? The SimpleBot Shield is for you! The SimpleBot Shield kit is an Ar...

FT-SBS

This handy ruler is perfect for your electronics bench: designed specifically for electronics engineers, it includes 1mm graduations on one edge an...

FT-RULER

This 2-wheel-drive chassis kit is easy to assemble, and can be combined with other parts to build your own little robot. Requires minor soldering ...

FT-ROBOT2WD

If you have damaged your 4x4x4 RGB LED Cube during assembly or need to replace some LEDs then order this pack to repair your cube. We also offer th...

FT-RGB8CC

Huge 8mm RGB (Red Green Blue) LEDs in a 4-pin package with a common anode connection. Great for building colourful displays or status indicators th...

FT-RGB8CA

This sensor incorporates two QRE1113 infra-red reflectance sensors on a single PCB, spaced just the right distance apart to build a line following ...

FT-REFLECT

RetiredOur version v3.1 ProtoShield Pro is (we humbly believe!) the best Arduino prototyping shield ever designed. Not making any bold claims or an...

FT-PSP

Note: This regulator module is designed for use with commercial PoE systems such as Ethernet switches with 802.3af support that can push a nominal ...

FT-POEREG

This product has been discontinued and replaced with the upgraded PR28V linked here. This page is left for reference purposes. Note: This regulato...

FT-POE-REG-24V

The PiLeven is an Arduino Uno compatible board that fits directly onto a Raspberry Pi, giving you the best of both worlds. You can run a full opera...

FT-PILV

Build your own cellphone! Based on the ATmega1284P, ArduPhone lets you build mobile phone functionality into your Arduino projects or even to use a...

FT-PHONE

Quickly and easily connect the 128x128 pixel OLED module to the LeoStick Arduino-compatible board for a tiny, handy display! Resources OLED Stick ...

FT-OLST

Directly control up to 6 separate high-power loads such as high-intensity LEDs, lamps, motors, and relays. Incorporates 6 N-channel MOSFETs, each c...

FT-NSHIELD

This high-power N-MOSFET module lets you switch high-current loads using a tiny microcontroller. Perfect for controlling that set of traffic lights...

FT-NDRIVE

This handy cable is the same as the ones we ship with our boards such as the Eleven, EtherMega, and EtherTen. Perfect for connecting your Arduino c...

FT-MUSB

  Designed by Luke Weston This self-contained Arduino-compatible datalogger kit incorporates a variety of sensors that make it perfect for mobile...

FT-MOBSENDAT

 New product, coming soon! Stock expected in mid September. Assign a unique MAC address to your network-connected projects using our MAC Address M...

FT-MACMOD

LIN Bus (Local Interconnect Network) is a simple serial bus that was originally developed for use in vehicle electronics, but is also used by AXA e...

FT-LINMOD

The LeoStick is designed to be functionally similar to the Arduino Leonardo, but given the "honey, I shrunk the kids" treatment!Just pop it into yo...

FT-LEOSTICK

The LCD and Keypad Shield gives you a handy 16-character by 2-line display, 5 buttons and a controllable backlight, plug it straight in on top of y...

FT-LCDK

The KitTen is an Arduino compatible board supplied as a kit using through-hole parts for easy assembly. It may be easy to build, but it's still fu...

FT-KITTEN

Remote temperature sensing for your Arduino! Connect this to your board and point it at a surface or heat source to remotely measure its temperatur...

FT-IRTEMP

Power-over-Ethernet uses your LAN to send power via the network cable to whatever device you have connected at the other end, saving you the hassle...

FT-INJ4SS

Power-over-Ethernet uses your LAN to send power via the network cable to whatever device you have connected at the other end, saving you the hassle...

FT-INJ4CH

Measure location, altitude, and speed using your Arduino and this module. Simple serial interface with full Arduino library support. Onboard backup...

FT-GPS

[Update - we're taking feedback for a new '1284P-powered board!] Have you run out of RAM in your project, and find the Uno just doesn't quite cut ...

FT-GOLDILOCKS

RETIRED This product has been replaced by the USB-Serial Adapter. Many Arduino boards save expense by leaving off the USB-to-Serial converter, pr...

FT-FTDI5V

This is a colour LED with a brain! Includes a bright WS2812B addressable RGB LED. This smart module can be daisy-chained, so you can connect a numb...

FT-FREEPIXEL

Addressable LEDs such as FreePixels are great for chaining a bunch of LEDs together and driving them with a single data pin from your microcontrol...

FT-FREENFET3

Addressable LEDs such as FreePixels are great for chaining a bunch of LEDs together and driving them with a single data pin from your microcontrol...

FT-FREENFET

Connects to standard hobby servos and extends their cable length by 600mm, using standard Futaba style male and female connectors. This is a high-...

FT-EXT600

Connects to standard hobby servos and extends their cable length by 300mm, using standard Futaba style male and female connectors. This is a high-...

FT-EXT300

Servo motor, lights, buttons, switches, sound, sensors, breadboard, wires and more are included with a Freetronics Eleven Arduino-compatible board...

FT-EXPKIT

Run out of digital outputs on your microcontroller? No problem! Simply use this shift register expansion module to drive up to 8 devices using just...

FT-EXPAND

The EUP3476 is a very handy little switchmode voltage regulator that we use on a few of our products, including the EtherMega and the 28V Power Reg...

FT-EUP3476

The ESP-01 WiFi Module Shield lets you easily plug an ESP-01 WiFi Module into your Arduino. Note: ESP-01 WiFi Module not included. The ESP-01 is ...

FT-ESP1SH

Put your Arduino online with the Freetronics Ethernet Shield and have it talk to the world. Do Twitter updates automatically, serve web pages, conn...

FT-ES

  Oodles of ARM-based power, Ethernet network connectivity, MicroSD storage, and the simplicity and ease of the Arduino IDE (with 100% compatibili...

FT-ED

A huge dot matrix LED panel to connect to your Freetronics Eleven, EtherTen and more! This large, bright 512 LED matrix panel has on-board control...

FT-DMDRED

A huge dot matrix LED panel to connect to your Freetronics Eleven, EtherTen and more! This large, bright 512 LED matrix panel has on-board control...

FT-DMDGREEN

This handy Dot Matrix Display Connector allows you to plug an LED panel straight in to an Arduino-compatible board. Our big, bright LED panels co...

FT-DMDCON

A huge dot matrix LED panel to connect to your Freetronics Eleven, EtherTen and more! This large, bright 512 LED matrix panel has on-board control...

FT-DMDBLUE