Not Zero Margin Goods

This is a simple four wire cable. Great for jumping from board to board or just about anything else. These cables mate with the connectors listed b...

SF-PRT-10359

While our small diagonal cutters are great for hobby use, sometimes you need something with a little more bite. These electronic snippers are great...

SF-TOL-10447

This cable can serve as a generic, 6-conductor ribbon cable with 6×1 0.1" female connectors on both ends, but it is designed for chaining ShiftBri...

PL-1239

DescriptionNEOFLASH is a RGB LED panel with 192 RGB LED(24x8). When you program this Unit, please pay attention to the sequence of the Neopixels. F...

M5-A042

Pump out some mini beats with Pirate Audio Speaker! This diminutive sound system has an I2S DAC, amp, mini mono speaker, high-res display, and play...

PR-PIM485

Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft, diffuse glow. Features: 3.0-3.4VDC Forwar...

SF-COM-11121

A four pack of sewable, star-shaped bright blue LEDs. The voltage (and hence current) supplied from LIR2032 rechargeable coin cell batteries may da...

PI-TEK003

The Teknikio Light Sensor Board is the easiest way to activate your sewable projects with light. It runs off their Battery Board and has two modes:...

PI-TEK006

Add a tiny yet convenient power switch to your Pi with OnOff SHIM! Our SHIMs (Shove Hardware in the Middle) are a new range of boards designed to b...

PR-PIM277

Just about all electronics use a UART serial port with RX and TX pins for debugging, bootloading, programming, serial output, etc. But it's rare f...

AF-4331

DescriptionEARTH unit is a Soil Moisture Sensor for measuring the moisture in soil and similar materials.The soil moisture sensor is pretty straigh...

M5-U019

These are your run-of-the-mill 1/4 Watt  5-band resistors. Commonly used in breadboards and other prototyping applications, these 47 ohm resistors ...

LB-LS0317-47

To be used in any number of situations including RF shielding. * Foil thickness: 0.04mm * Raw material: Aluminum foil, Acrylic...

TB-NM2860

The 555 timer is one of the most used and useful ICs ever produced. Designed in 1971 by Hans Camenzind it provides a way to include different metho...

PI-COM0208

PL-3434

Now that you've finally got your hands on a Raspberry Pi® , you're probably itching to make some fun embedded computer projects with it. What you n...

AF-1754

This connector with leads makes a great power cable. The connector is keyed so that power cannot be reversed, and a latch secures the connection ...

PL-2179

This is a multifunction air quality monitor that can be detected not only the concentration of particles and formaldehyde but also the value of te...

DF-SEN0233

Standard frequency crystals - use these crystals to provide a clock input to your microprocessor. Rated at 20pF capacitance and +/- 50ppm stability...

SF-COM-00535

Why use a heatsink and a case, when you can use a heatsink case?! This purple, anodised aluminium case for the Raspberry Pi 4 will give you 10-15°C...

SF-PRT-15894

30 x SCRU - Connects up to three layers of corrugated cardboard.10 x SCRU XL - Connects up to six layers of corrugated cardboard.1 x Bonus Mini-Too...

MD-6A040

CONNECT EASILY:1 x SCRU-DRIVER Connect cardboard as simply as righty tighty, lefty loosey. For use with the Makedo SCRU and SCRU XL:Simply punch a ...

MD-5D001

Overview These 0.1" female header strips are commonly used as low-cost connectors for custom-made cables or perforated prototyping PCBs. The stan...

PL-2705