SparkFun Australia

A Wide Band, 700-2700Mhz frequency range, 4G LTE antenna provides a wide enough range for a number of applications including BLE & LoRa/RF. Thi...

SF-WRL-17841

The MicroMod ESP32 Processor Board combines Espressif's ESP32 with our M.2 connector interface to bring a processor board with reliable WiFi and Bl...

SF-WRL-16781

This is the Antenna Kit for the Raspberry Pi 4 Compute Module wireless variants. The “duck” style antenna adds range to the wireless radio on the w...

SF-WRL-17389

The Raspberry Pi Compute Module 4 represents a huge change for the Compute Module line. The biggest change being the move from the DDR2 SODIMM conn...

SF-DEV-17384

This USB 2.0 Type C cable is perfect for use with your Raspberry Pi 4 and other USB Type C boards. USB Type-C Connectors and Cable Assemblies offer...

SF-CAB-16905

The SparkFun SerLCD is an AVR-based, serial enabled LCD that provides a simple and cost effective solution for adding a 16x2 Black on RGB Liquid Cr...

SF-LCD-16396

If you are not needing a lot of power to start your FPGA adventure, or are looking for a more economical option, the Alchitry Cu FPGA Development B...

SF-DEV-16526

These are simple 6-position screw terminals with 2.54mm pitch pins. Rated up to 150V @ 6A, this terminal can accept 30 to 18AWG wire. The 2.54mm pi...

SF-PRT-16499

With GPS you are able to know where you are, where you're going, and how to get there anywhere on Earth within 30 seconds. This means the higher th...

SF-GPS-16481

The SparkFun moto:bit is a fully loaded "carrier" board for the micro:bit that, when combined with the micro:bit, provides you with a fully functio...

SF-DEV-15713

This sturdy carrying case is great for carrying anything from tiny components to medium-sized tools. With its adjustable dividers, it could be used...

SF-PRT-15698

Make you Raspberry Pi 4 seriously cool with the Fan SHIM from Pimoroni! This 30mm no-solder, controllable CPU fan with RGB LED and tactile switch w...

SF-PRT-15708

The W25Q32FV (32M-bit) Serial Flash memory provides a storage solution for systems with limited space, pins, and power. This small SMD IC series of...

SF-COM-15809

This is a tiny USB Microphone from Kinobo that plugs into your laptop, desktop, Raspberry Pi, Jetson Nano Dev kit, anything with a USB port you may...

SF-COM-14125

This panel mount USB-B (female) to micro-B (male) cable enables you to more easily enclose a project that contains a USB micro-B port. The cable is...

SF-CAB-15463

The SparkFun BME280 Atmospheric Sensor Breakout is an easy way to measure barometric pressure, humidity, and temperature readings, all without taki...

SF-SEN-15440

In the next iteration of the Model B line, Raspberry Pi has given us the very powerful Model B 4 with the goal of the credit card sized development...

SF-DEV-15446

The SparkFun Lightning Detector adds lightning detection to your next weather station to make sure you are aware of any potential hazardous weather...

SF-SEN-15441

USB-C is fantastic. What makes this cable even better is that one of the features we love so much about USB-C has been replicated to the USB-A 2.0 ...

SF-CAB-15426

This is a 150mm (~6") long, 10-conductor cable that's especially ideal for many JTAG applications. Both ends are terminated with 2x5 pin female con...

SF-CAB-15364

Is it power you seek? With a 32-bit ARM Cortex-M4F MCU, the SparkFun SAMD51 Thing Plus is one of our most powerful microcontroller boards yet! The ...

SF-DEV-14713

The SparkFun micro:climate kit is a full weather station kit that is built on top of the weather:bit carrier board. Unlike previous weather kits we...

SF-KIT-15301

The OpenMV H7 Camera is a small, low power, microcontroller board which allows you to easily implement applications using machine vision in the rea...

SF-SEN-15325

Having a broken phone or electronics device stinks, whether it's a screen going out, a cable becoming unplugged, or even a more severe issue that w...

SF-TOL-15255

Alligator clips (or Crocodile clips, if you prefer) are likely to be the most useful thing on your workbench besides the workbench itself. Whether ...

SF-DD-15333

Keypads are very handy input devices, but who wants to tie up seven GPIO pins, wire up a handful of pull-up resistors, and write firmware that wast...

SF-COM-15290

The Raspberry Pi PoE (Power over Ethernet) HAT is a small accessory board for the Raspberry Pi computer. The PoE HAT allows you to power your Raspb...

SF-DEV-14882

The Molex GNSS Flex antenna is a great option for basic GNSS applications and will work with any of our GNSS boards equipped with a U.FL at a fract...

SF-GPS-15246

This SparkFun Distance Sensor Breakout utilizes the VL53L1X next generation ToF (Time of Flight) sensor module to give you the highly accurate...

SF-SEN-14722

This simple adapter wire terminates on one end with a JST-PH Male connector, and a JST-SM Female connector on the other. It can be used as a bridge...

SF-PRT-14707

This is a 10-pack of wires that are pre-terminated with an alligator clip on one end and a female header on the other. Alligator clips are a staple...

SF-CAB-15186

This is a basic 16 button keypad that has been designed for easy user input and functionality. The buttons are set up in a matrix format which allo...

SF-DD-14881

This breakout board makes it easy to use the tiny MMA8452Q accelerometer communicate over I2C in your project. The MMA8452Q is a smart low-pow...

SF-SEN-14587

Normal GPS antennas are optimized for the US based GPS reception which is great but with more and more modules capable of tracking additional const...

SF-GPS-14986

Color your world with this MegaPack of multi-colored circuit stickers. This LED sticker pack from Chibitronics is a set of 30 individual red, yello...

SF-DEV-14594