SparkFun Australia

This is a set of four 2x18 female headers with 0.1"-spaced pins for the Alchitry Br Prototype Element Boards. These line up exactly with all the br...

SF-PRT-15874

The Alchitry Io Element Board is the perfect way to get your feet wet with digital design. The Io features four 7-segment LEDs, five momentary push...

SF-DEV-15849

You'll have no need for a screwdriver with this terminal! This is a 3-pin Latch Terminal with 5mm pitch pins. Each pin is rated up to 250V @ 11A an...

SF-PRT-15900

Qwiic has struck again! This MEMS, three axis accelerometer by STMicroelectronics has been outfitted to communicate over Qwiic. The LIS2DH12 is an ...

SF-SPX-15760

It's time to effectively manage the power distribution into your project and with the SparkFun Power Delivery Board, you can! Traditional power ada...

SF-DEV-15801

A preposterous pile of peripherals on your Pi! The fully assembled pHAT Stack by Pimoroni is the ultimate way to add HATs, pHATs, wHATs, and everyt...

SF-DEV-16303

Why use a heatsink and a case, when you can use a heatsink case?! This purple, anodised aluminium case for the Raspberry Pi 4 will give you 10-15°C...

SF-PRT-15894

The SparkFun Qwiic Shield for Thing Plus provides you with a quick and easy way to enter into SparkFun's Qwiic ecosystem with your Thing Plus or F...

SF-DEV-16138

The SparkFun Qwiic Shield for Arduino Nano provides you with a quick and easy way to enter into SparkFun's Qwiic ecosystem with your Arduino Nano ...

SF-DEV-16130

The SparkFun Qwiic TMP117 breakout is a high precision temperature sensor equipped with an I2C interface. It outputs temperature readings with high...

SF-SEN-15805

This 4-pin, ATX, right angle connector mates up to the standard 4-pin computer peripheral port often found on ATX power supplies. This connector wi...

SF-PRT-15700

Do you need to power a project with 12V and 5V from one power supply? The ATX power connector breakout board breaks out the standard 4-pin computer...

SF-BOB-15035

Looking for a super small microcontroller to use with the Qwiic eco-system? The SparkFun Qwiic Micro is molded to fit our standard 1"x1" Qwiic stan...

SF-DEV-15423

Why use a heatsink and a case, when you can use a heatsink case?! This gunmetal, anodised aluminium case for the Raspberry Pi 4 will give you 10-15...

SF-PRT-15775

Looking to get started with the SparkFun Qwiic system? The Qwiic Pro kit provides you with a RedBoard Turbo, two sensors, two accessory boards, and...

SF-KIT-15349

If you are looking for a board that (almost) does it all, look no further! The SparkFun Artemis Thing Plus takes our popular Thing Plus footprint a...

SF-WRL-15574

Edge computing is here! You've probably heard of this latest entry to the long lineage of tech buzzwords like "IoT," "LoRa," and "cloud" before it,...

SF-DEV-15420

The SparkFun Pulse Oximeter and Heart Rate Sensor is an I2C based biometric sensor, utilizing two chips from Maxim Integrated: the MAX32664 Biometr...

SF-SEN-15219

We like to joke the Artemis Nano is a party on the front and business on the back. And that's by design! All the important LEDs, connectors, labels...

SF-DEV-15443

The Artemis Module from SparkFun is a Cortex-M4F with BLE 5.0 running up to 96MHz and with as low power as 6uA per MHz (less than 5mW). This is the...

SF-WRL-15484

This is a class 10 16GB microSD memory card, perfect for housing operating systems for single board computers and a multitude of other information....

SF-COM-15051

The Edimax 2-in-1 WiFi and Bluetooth 4.0 Adapter (EW-7611ULB) is a nano-sized USB Wi-Fi adapter with Bluetooth 4.0 that supports Wi-Fi up to 150Mbp...

SF-WRL-15449

The SparkFun gator:UV micro:bit Accessory Board is an ultraviolet sensing solution created to interface with the micro:bit as easily as possible. A...

SF-SEN-15273

According to some of our engineers, if you hold this Qwiic Arcade switch up next to your ear, you can hear the sounds of Pac-Man scrolling across t...

SF-SPX-15592

This is a class 10, 16GB, micro SDHC card that has been pre-installed with the NOOBS operating system for the Raspberry Pi produced in house here a...

SF-COM-15052

Looking for an option to sense ambient light? The VEML6030 Qwiic board is a great starter option. The VEML6030 is a high accuracy ambient light sen...

SF-SEN-15436

The MCP9600 is a high accuracy thermocouple amplifier equipped with an I2C interface, accessed over our Qwiic system. Inside the chip are two tempe...

SF-SPX-15508

There are a couple must-have boards that every engineer and hobbyest should have on their desk, and this PCA9306 dual, bidirectional voltage-level ...

SF-BOB-15439

Ready to get started with Raspberry Pi and Qwiic? We have everything needed to get you started using Qwiic on your Raspberry Pi. The SparkFun Qwiic...

SF-KIT-15367

USB-C is fantastic. What makes this cable even better is that one of the features we love so much about USB-C has been replicated to the USB-A 2.0 ...

SF-CAB-15424

These are your standard issue USB 2.0 type A to micro USB 5-pin... but wait, what's this? These cables have minor, yet genius modifications that al...

SF-CAB-15428

If your plants could talk, would they call out "Water me, Seymour?" Unfortunately (or fortunately, perhaps) plants have yet to develop the ability ...

SF-SEN-15272

The SparkFun gator:microphone is a micro:bit Accessory Board that integrates an electret microphone into SparkFun's gator:bit series of gator-clipp...

SF-SEN-15289

Do you want to replace a slider or a button on your art project or science experiment with a more interesting interface? This Capacitive Touch Slid...

SF-SEN-15344

This is a super small, 2x5 pin female PTH header. This header is in the common configuration for JTAG applications. Each pin has a spacing of 1.27m...

SF-PRT-15363

Fingerprint scanners have been easily available at a consumer level for a number of years now, so it is only logical that they would continue to gr...

SF-SEN-15338

A lot of the time you just need to add more analog inputs to solve a problem. It happens. The SparkFun Qwiic 12 Bit ADC can provide four channels o...

SF-DEV-15334

The SparkFun gator:environment micro:bit Accessory Board utilizes the popular CCS811 and BME280 ICs to take care of all of your environmental readi...

SF-SEN-15269

The J-Link line of JTAG programmers from Segger is well known for their top of the line debuggers. A low-cost J-Link for educational purposes, the ...

SF-PGM-15346

The SparkFun Inventor's Kit for micro:bit Lab Pack includes 10 complete micro:bit Inventor's Kits, an SIK Refill Pack and 25 AAA-sized batteries to...

SF-LAB-15229

The SparkFun Inventor’s Kit (SIK) for micro:bit is a great way to get creative, connected and coding with the micro:bit. The SIK for micro:bit prov...

SF-KIT-15228

The SparkFun Buck-Boost Converter is a handy power accessory board that allows you to fine tune the amount of power your project receives. This con...

SF-COM-15208

Having a broken phone or electronics device stinks, whether it's a screen going out, a cable becoming unplugged, or even build-up in the USB port. ...

SF-TOL-15256

There are lots of trimpots out there. Some are very large, some so small they require a screwdriver. Here at SparkFun, we just needed a simple one ...

SF-DD-15298

These are bare addressable 1 meter long 5V RGB LED strips that come packed with 60 APA104s per meter. As these are bare LED strips that have no pro...

SF-COM-15206

The SparkFun SAM-M8Q GPS Breakout is a high quality, GPS board with equally impressive configuration options. The SAM-M8Q is a 72-channel GNSS rece...

SF-GPS-15210

The SparkFun ZOE-M8Q GPS Breakout is a high accuracy, miniaturized, GPS board that is perfect for applications that don't possess a lot of space. T...

SF-GPS-15193

The SparkFun ESP32 Thing Plus DMX to LED Shield is the perfect way to send and receive DMX data. Whether it's coming in via the onboard XLR-3 jack ...

SF-DEV-15110